User Manual

3.2. Assembling your system
1. Fix the cross and handlebar with the screws provided. Tighten moderately.
2. Fix the second cross on the other side of the handlebar. Firmly tighten the four
screws on the handle bar.
3. Place the RackBrute on a clean, flat surface. Insert the tightening washer on the
quick fastening screw.
4. Moderately fasten the quick fastening screw on the orange Link port.
5. Repeat the operation on the other side.
6. Put the RackBrute on its standing position.
7. Make sure the RackBrute is at its maximum and firmly tighten both quick
fastening screws.

♪: The procedure for linking compatible Link units to each other such as the 6U, 3U, 2 and
2S is similar. Remember: do not connect/disconnect modules when the rack is powered. Warning:
Intermediary positions of the Brute system cannot be fully secured with the quick fastening screws.
When opening and closing the unit you should always loosen the Link port. ! Important note: Do not
connect/disconnect modules when the rack is powered.
Setting up the Rack
Arturia - User Manual RackBrute 3U & 6U - The RackBrute Case 6