User Manual

14 ARTURIA – KeyLab – USER’S MANUAL
• For a knob or fader in NRPN/RPN mode, contains the NRPN/RPN controller
number LSB (Less Significant Byte).
• For a button in Ctl mode, holds the value sent at release time.
• For a button in Prog mode, holds the bank LSB.
• For a button in Note mode, holds note off velocity.
Max MSB Various functions depending on the controller:
• For a knob, pad or fader in Ctrl mode, contains the maximum value sent.
• For a knob or fader in NRPN/RPN mode, contains the NRPN/RPN controller
number MSB (Most Significant Byte).
• For a button in Ctl mode, holds the value sent at press time.
• For a button in Prog mode, holds the bank MSB.
• For a button in Note mode, holds note on velocity.
It’s perfectly fine for Min to be greater than Max, in that case the control is effectively inverted.
Global Used to set the global parameters of the current preset:
• FaderMod: fader draw bar mode, Normal or Drawbar.
• KnobMode: knob mode, Absolute or Relative.
• OctTrans: octave transposition, from -3 to +3 octaves.
• ChroTrns: chromatic transposition, from -12 to +12 semitones.
• LowerCh: lower MIDI Channel, from 1 to 16.
• UpperCh: upper MIDI Channel, from 1 to 16.
• SplitMod: split mode, On or Off.
• SplitPnt: split point, from C-2 to G8.
• MMCDevID: MMC device ID, from 0 to 127.
• DeviceID: this device ID, from 16 to 127.
When editing the split point, hitting a key on the music keyboard should set the split point accordingly
(without preventing this strike to have the usual effect).
Curve Used to set the global curves, the following settings are available:
• Velocity: the Velocity curve, from 0 to 10
• Aftertch: the Aftertouch curve, from 0 to 10
• PadVeloc: the Pad velocity curve, from 0 to 10
• KnobAccl: the Knob acceleration, from 0 to 10
• KeyATmin: the Minimum Key aftertouch, from 0 to 127
• KeyATMax: the Maximum Key aftertouch, from 0 to 127
• PadATmin: the Minimum Pad aftertouch, from 0 to 127
• PadATMax: the Maximum Pad aftertouch, from 0 to 127