Installation Guide

37
Step 12: Roof Trim
37H
Roof Trim Caps are positioned as shown.
You will need for this page:
Slide Peak Cap legs under Ridge Cap and secure
Ridge Cap ends with four Small Bolts and Nuts on
each end as shown.
1
3
If you are erecting a 10’x15’ (3,0 m x 4,6 m) or
larger building, install Mid Roof Trim along the re-
mainder of the roof edge. Roof Trim overlaps as
shown to the right.
2
Position Left and Right Roof Trim as shown below
and secure with Small Screws. Do not fasten the
last Screw on each end. Pay close attention to
where the Left and Right Roof Trim pieces are located.
Left Trim
2
80017
Right Trim
2
10620
Trim Cap (L)
2
Trim Cap (R)
2
Peak Cap
2
(QTY: 16+)
(QTY: 8)
80017
Left Roof Trim
10620
Right Roof Trim
10620
Right Roof Trim
80017
Left Roof Trim
(QTY: 4)
Insert a Small Screw where Roof
Trim overlaps after installing.
Position the Roof Trim Caps as shown below and
secure with a Small Screw. Using your thumb
and index fi nger, overbend the bottom fl ange of the
Side Roof Trim at the corner inward enough so the right
and left Roof Trim Caps fi t onto right and left corners.
4
6015
Mid Roof Trim
6015
Mid Roof Trim
Mid Trim
0+
6015
SBSSSS
SB
SB
10’x15’ (3,0 m x 4,6 m)
building shown.