1/10 BIG ROCK 4X4 3S BLX Manual

WWW.ARRMA-RC.COM
Variable Setting > 1 2 3 4 5 6 7
1 Low Voltage Cut-O󰀨 Threshold
LIPO NIMH
2 Punch Setting
Level 1 Level 2 Level 3 Level 4 Level 5
3 Brake Strength
25% 37.5% 50% 62.5% 75% 87.5% 100%
4 Running Mode
Fwd/Brk/Rev Fwd/Brk
5 Motor Rotation
Normal
(CCW)
Reverse
(CW)
If the ESC temperature exceeds 105 degrees Celsius/221 degrees Fahrenheit, the ESC will
enter temperature protection mode and the green status LED will blink. Once the ESC has
cooled down it will resume normal operation after it has been turned o󰀨 and back on again.
Temperature Protection
ESC Tuning Options
The ARRMA BLX brushless ESC is setup for use straight from the factory, if you want to alter the
settings for your track or driving style please see the table and steps below:
A
B
Factory Reset
To reset the ESC to factory default settings, connect a battery, turn the transmitter on and then turn
the car on. Press and hold the set button for 4 seconds and release. The Red and Green lights will
ash simultaneously to show you have reset. Switch the ESC o󰀨 and factory reset is complete.
1. Connect a battery. Press and
hold the set button and turn on
ESC. The RED LED will ash.
2. Keep holding the set button
and you will see the GREEN
LED ash/beep (the number of
green ashes represents the
variable number).
3. To enter the selected
variable, release the set button
on the desired number of
ashes/beeps.
4. Using the tuning chart, press
the ‘set’ button until the number
of red LED ashes and short
beeps equals the required value.
5. To save the setting,
switch the ESC o󰀨. Restart
the process to make more
changes.
To alter ESC settings
If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
Battery Modes
Power LED
Steering dual rate
16