User's Manual
Table Of Contents
- Table of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Device Configuration
- Important Safety Instructions
- Motorola® Gateway Status Indicator Lights
- Battery Installation (optional)
- Battery Door Installation Instructions
- Battery Door Removal Instructions
- Cradle Installation Instructions
- Set up the Motorola Gateway
- Accessing the Web Management Interface
- Device Status page
- Tab Bar
- Help
- Links Bar
- Broadband
- Home Network
- Voice
- Firewall
- Diagnostics
- CHAPTER 3 Basic Troubleshooting
- CHAPTER 4 Command Line Interface
- Overview
- Starting and Ending a CLI Session
- Using the CLI Help Facility
- About SHELL Commands
- SHELL Commands
- About CONFIG Commands
- CONFIG Commands
- Connection commands
- Filterset commands
- Queue commands
- IP Gateway commands
- IPv6 Commands
- IP DNS commands
- IP IGMP commands
- NTP commands
- Application Layer Gateway (ALG) commands
- Dynamic DNS Commands
- Link commands
- Management commands
- Remote access commands
- Physical interfaces commands
- PPPoE relay commands
- NAT Pinhole commands
- Security Stateful Packet Inspection (SPI) commands
- VoIP commands
- System commands
- Debug Commands
- CHAPTER 5 Technical Specifications and Safety Information
- Appendix A Motorola® Gateway Captive Portal Implementation
- Appendix B Quality of Service (QoS) Examples
- Index
55
◆ You can test the performance of each station to station pair by clicking the Run extended Test button. When
you click the
Run extended Test button, the following page appears as a warning about this invasive test.
If you do not run the Extended Test, the station-to-station performance section is not displayed.
◆ You can generate updated statistics by clicking the Refresh button.
Furnished statistics of the current and previous intervals are displayed as follows:
◆ Station ID
◆ HPNA MAC Address
◆ HPNA Firmware (C-coax, T=TP)
◆ HPNA Version
◆ HPNA Master
Interval Start Interval Stop
Short Tx Pkt This is the number of Transmitted Packets
Short Rx Pkt This is the number of Received Packets
CRC Errors Rx This is the number of Receipt errors
Dropped Tx This is the number of Transmit packets dropped
Dropped Rx This is the number of Receipt packets dropped
Tx Error % This is the percentage of transmitted errors
Rx Error % This is the percentage of receipt errors
Frames Tx This is the number of frames transmitted
Frames Rx This is the number of frames received
Bytes Tx This is the number of bytes transmitted
Bytes Rx This is the number of bytes received
Unicast Tx This is the number of unicast packets transmitted
Unicast Rx This is the number of unicast packets received
Multicast Tx This is the number of multicast packets transmitted
Multicast Rx This is the number of multicast packets received
Local Control Req This is the number of requests made to the device by local control
Local Control Repl This is the number of replies made by the device to local control
Remote Control Req This is the number of requests made to the device by remote control
Remote Control Repl This is the number of replies made by the device to remote control