Use and Care Manual

15
Maintenance Procedures for the Application of Floor Finish (Polish)
Products: VCT and BIO–Required
Armstrong Flooring commercial Vinyl Composition Tile and Bio-Flooring are coated with the Fast Start
®
Factory Finish. Fortunately,
the Fast Start
®
Factory Finish makes initial maintenance quick and easy and does not require removal after installation. It is compatible
with commercial floor polishes (such as Armstrong Flooring S-480 Commercial Floor Polish) and reduces the need to strip the tile.
These products require polishing for protection, ease of maintenance and for long term apperance retention.
A. Initial Maintenance – Immediately After Installation
1. Sweep, dust mop or vacuum the floor thoroughly to remove all loose dust, dirt, grit and debris.
2. Remove any dried adhesive residue with a clean white cloth dampened with mineral spirits, carefully following warnings on the
container.
3. Damp mop the floor with a properly diluted neutral (pH 6 to 8) detergent solution, such as Armstrong Flooring S-485 Commercial
Floor Cleaner.
4. IMPORTANT: Apply a minimum of 2 coats of a high-quality commercial floor polish (such as Armstrong Flooring S-480
Commercial Floor Polish) to temporarily protect the floor until regular maintenance procedures can begin. The use of a
high-quality stain-resistant sealer (such as Armstrong
Flooring S-495 Commercial Floor Sealer) beneath the polish should be
considered in areas of high traffic, high soil load and areas where staining potential is high.
B. Initial Maintenance–Preparation for Commercial Traffic
1. Machine scrub the floor with a properly diluted neutral (pH 6 to 8) detergent solution (such as Armstrong
Flooring S-485
Commercial Floor Cleaner) and a scrubbing pad (3M
™
blue or equal) or equivalent brushes.
˚
If the floor is badly soiled and/or scratched, strip it using the same procedure, but substituting a properly diluted stripping
solution
NOTE: The use of aggressive strippers such as mop-on/mop-off, no-scrub and no-rinse strippers is not recommended on tile floors less than two
years old because they may affect the adhesive bond.
2. Thoroughly rinse the entire floor with fresh, clean water. Remove rinse water and allow the floor to dry completely.
3. Apply 3 to 5 coats of high-quality commercial floor polish, such as Armstrong Flooring S-480 Commercial Floor Polish.
˚
If the floor has been stripped, the application of a stain resistant sealer (such as Armstrong Flooring S-495 Commercial
Floor Sealer) prior to the application of polish, is recommended in areas that will be exposed to heavy traffic and/or staining
agents
C. Daily/Regular Maintenance
1. Sweep, dust mop or vacuum the floor daily to remove dust, dirt, grit and debris that can damage the floor and become ground
into the surface.
2. Spot mop as needed. Any spills should be cleaned up immediately.
3. Damp mopping of the floor should be performed on a regular or daily basis, depending upon traffic and soil levels in the space.
Use a properly diluted neutral (pH 6 to 8) detergent solution, such as Armstrong Flooring S-485 Commercial Floor Cleaner.
D. Periodic Maintenance
1. When needed, after sweeping, dust mopping or vacuuming, machine scrub the floor with a properly diluted neutral (pH 6 to 8)
detergent solution (such as Armstrong Flooring S-485 Commercial Floor Cleaner) and the appropriate scrubbing pad
(3M
™
red or equal for light scrub, 3M
™
blue or equal for a deep scrub) or equivalent brush.