Arlo Pro 2 Wire-Free HD Security Camera Quick Start Guide
What’s Included Thank you for choosing Arlo Pro 2. Getting started is easy.
Use Your Camera Wire-Free Sync Your Camera With the Base Station Before using your camera wire-free, you must insert the battery. 1. Note: You do not need to insert the battery if you are connecting your Arlo camera to an AC power outlet. Note: Cameras must be synced one at a time. Bring the camera within 1 to 3 feet (30 to 100 centimeters) of the base station. ¾¾ To insert the battery: 1. Unlock the battery compartment by pressing and holding the latch. 2.
2. Press the Sync button on the top of the base station for about two seconds. 5. Press the Sync button on top of the camera for about two seconds. 3. Release the button. 6. 4. Wait for the Sync Status LED to blink green. Release the button. The LED lights as follows: • A blue LED on the camera blinks slowly when the sync process starts. • The blue LED blinks rapidly to confirm sync. • The LED blinks amber if the sync is not successful.
Charge Your Arlo Battery The Arlo battery is fully charged when it leaves the factory. 4. Plug the power adapter into an electrical outlet. ¾¾ To recharge the battery: 1. Place the camera indoors. If you are using the camera outside, bring it inside while charging the battery. 2. Connect the power adapter cable to the camera power adapter. Note: You must use an Arlo Pro 2 power adapter and cable to charge the battery. 3. 8 The camera LED lights solid blue when the camera battery is fully charged.
Use Your Camera Plugged In You’re Done! You can use your camera wire-free, powered by the battery, or while plugged into an AC power outlet. Congratulations! Your Arlo camera is set up and ready to go. ¾¾ To use your camera plugged in: 1. Place the camera indoors or use the optional outdoor power adapter, sold separately, when placing outdoors.. 2. Connect the power adapter to an AC electrical outlet.
Camera LED Guide 12 Notes General Syncing Charging Blinks blue once The camera is powered on. Slow blinking blue The camera is searching for a base station. Fast blinking blue The camera is connected to power. Blinking blue and amber A firmware update is in progress. DO NOT TURN OFF THE CAMERA. Fast blinking blue The camera is syncing with a base station. Solid blue The camera is powered on and the battery is fully charged.
Notes 14 Notes 15
©NETGEAR, Inc., NETGEAR, the NETGEAR Logo, and Arlo are trademarks of NETGEAR, Inc. Compliance For the current EU Declaration of Conformity, visit http://kb.netgear.com/app/answers/detail/a_id/11621/. For regulatory compliance information, visit http://www.netgear.com/about/regulatory/.
