Installation & Assembly

Kit Components

Tools Required

x1 Track x2 Straight Strap x5 5/16 (8mm x 60mm)

Carriage Bolt

x2 #8 (4.2mm x 25mm)

Floor Screws

Tape Measure Pencil Cordless Drill Phillips Screwdriver Wrench Allen Key Level

x5 Wall Spacer x1 Right Stopper

x5 5/16 (8mm x25mm)

Anchor

x2 1/4 (6mm) Floor

Anchor

x2 Anti-jump Block x1 Left Stopper

x5 5/16 (8mm x 90mm)

Wall Screw

x1 Internal Floor-

Mounted Door Guide

x1 Door Handle

(Pre-mounted

to Carriage Bolt)

BARN DOOR HARDWARE INSTRUCTIONS

PAGE 1
BARN DOOR HARDWARE INSTRUCTIONS Kit Components x1 Track x5 Wall Spacer x2 Anti-jump Block x2 Straight Strap x1 Right Stopper x1 Left Stopper x5 5/16 (8mm x25mm) Anchor x5 5/16 (8mm x 90mm) Wall Screw x2 #8 (4.
PAGE 2
Door Preparation - Strap and Anti-jump block Your Barn Door arrives with holes for the hanging straps pre-drilled. Use the included carriage bolts to attach the straps to the door. Next, position each anti-jump bumper at least 2" in from the edge of the straps. Tighten slightly to secure in place Step 2. CONCRETE Wall Preparation Use your guide marks to position the track in place, ensuring that it is level. Mark the mounting holes on the track using a pencil.
PAGE 3
PAGE 4
Step 8. Floor-Mounted Door Guide Installation Step 9. Stopper Installation Position the floor-mounted door guide just outside the opening of the door frame. Slide the door side-to-side to test for functionality, then mark the holes with a pencil and pre-drill 1/4" holes. If drilling directly into a concrete floor, use the provided anchors. Slide the left and right stoppers onto the track and find the ideal location by testing the door in both open and closed positions.