EN WALL CERAMIC FAN HEATER OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. Ensure that the mains power complies with the voltage specified on the fan heater data plate (220-240V~/50Hz).
The appliance heats up slightly when in use. In order to avoid burns, do not let bare skin touch hot surfaces. Ensure that all objects are at least 1 meter from the front and sides of the appliance. Disconnect the mains power when the appliance is not used or for cleaning operations. Avoid using the fan heater in dusty environments or in the presence of inflammable vapours (e.g. in workshops or garages) or paint vapours. Do not place anything on the appliance, use the appliance to dry clothing.
It is not advisable to use extension cords, as these may overheat and cause the risk of fire. Do not use a single extension cord to operate multiple appliances. Do not immerse the cord, plug or any other element of the appliance in water or other liquids. Do not touch the plug with wet hands. Do not place the fan heater above or near another heat source. WARNING: AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING.
In the event of any problems (abnormal noise or a strange smell) switch off the appliance immediately, do not attempt to repair it and take it to your local after sales service. DESCRIPTION OF PARTS 4 1 5 2 3 A. B. C. Main switch (ON/OFF) Control panel and LCD Air outlet D. Air intake grill E. Remote control: inside a small space on the right side of the unit, covered by a sliding door. INSTALLATION INSTRUCTIONS The fan heater must be installed on a wall before operating.
CONTROL PANEL and LCD DISPLAY LCD on the unit ROOM TEMPERATURE DISPLAY TIMER DISPLAY SYMBOLS ON CONTROL PANEL SYMBOLS ON LCD DISPLAY By left, the symbols on the control panel of the unit correspond to following functions:: 1. SWING: SWINGING OF HORIZONTAL FLAPS 2. TEMPERATURE SETTING (THERMOSTAT) 3. HEATING MODES – ECO / COMFORT 4.
5. This heater has a built in temperature sensor, which automatically monitors the ambient temperature and turn on the machine to store the ambient temperature. The default temperature is 30 ℃. Press the TEMPERATURE SETTING button to select the temperature, up to the desired level (15-36 ℃). If the selected temperature is higher than the ambient temperature, the unit automatically turns on and heats up to the selected temperature is reached.