EN ELECTRIC CONVECTION HEATER OPERATING INSTRUCTIONS Read the instructions carefully before operating the convector or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damages. Store these instructions.
GENERAL SAFETY INFORMATION Use this convector only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. This convector is designed for domestic use. It must not be used for commercial or industrial purposes. Ensure that the mains voltage complies with that indicated on the convector data plate (220-240V/50Hz).
automatically, as there may be a risk of fire if the fan heater is covered or incorrectly positioned. Disconnect the mains power when the appliance is not used or for cleaning operations. To disconnect the convector, set the selector to 0 and remove the plug from the socket. Pull on the plug only. Do not pull the cord. Avoid placing fingers or foreign objects in the air inlet/outlet grilles, as this may lead to electric shock or fire and may damage the convector.
Do not insert and avoid accidental insertion of any external objects into the ventilation or discharge outlets as this may lead to electric shock, fire or damage the convector. A convector contains parts that generate arcs or sparks. It must not be used in potentially dangerous areas such as areas at risk of fire or explosion, or areas loaded with chemical substances or humidity. Do not use the convector on soft surfaces such as beds, where the grilles may be covered.
Turn the switch off and unplug before carrying out any maintenance work or moving the convector. Always unplug from the socket when the convector is not in use. WARNING: ALWAYS UNPLUG WHEN CARRYING OUT MAINTENANCE WORK OR MOVING THE CONVECTOR. Do not place anything on the convector; avoid placing wet garments on the convector. Turn the appliance off if unattended in order to avoid accidents.
The convector is available in two different versions: JAZZ Mode ECO/COMFORT/SUPER - 750/1250/2000 W - Thermostat and mode selector with turbo JAZZ T Modo ECO/COMFORT/SUPER - 750/1250/2000 W – Thermostat and mode selector with turbo and 24h timer. HOW TO ASSEMBLE THE FEET SUPPLIED The convector is packed without feet. These must therefore be assembled before using the appliance.
Room temperature can be regulated by rotating the thermostat clockwise to increase or anticlockwise to decrease temperature. When turning the panel on, we recommend turning the thermostat knob to maximum: then, when a pleasant room temperature has been obtained, turn the thermostat dial anticlockwise until the light of the active switch goes out. This way the panel will maintain that room temperature constant.
INFORMATION ON PROPER DISPOSAL OF THE APPLIANCE IN COMPLIANCE WITH EUROPEAN DIRECTIVE 2012/19/EU. When this appliance reaches the end of its useful life, it must not be disposed of together with household waste but must be delivered to appropriate separate waste disposal plants or to dealers that provide similar service.