EN CARBON FIBER PATIO HEATER IP55 PROTECTION: IDEAL FOR EXTERNAL USE OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to do so may lead to accidents and/or damage. Store these instructions.
GENERAL SAFETY INFORMATION Only use this outdoor carbon fiber heater as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. Make sure that the type of mains power complies with the electrical requirements of the outdoor carbon fiber heater (220-240V~/50Hz). This product is not a toy. Children under the age of 3 years must be kept out of reach unless properly supervised, to ensure that they do not play with the appliance.
Avoid using the outdoor carbon fiber heater in dusty environments or in the presence of flammable vapours (e.g. in workshops or garages). Do not place anything on the product; avoid placing wet garments on the outdoor carbon fibre heater. Use the appliance in a well-ventilated area. Avoid placing fingers or foreign objects in the air inlet/outlet grilles, as this may lead to electric shock or fire and may damage the appliance.
The carbon fiber appliance may cause the risk of fire if, while running, it is covered or comes into contact with flammable material including curtains, drapery, blankets, etc. KEEP THE PRODUCT AWAY FROM THESE MATERIALS. Do not connect the product to the power supply until it has been correctly assembled or positioned. Do not run the cord under carpets. Do not cover the cord with blankets, carpets or similar materials.
ASSEMBLY INSTRUCTIONS When installing the unit, make sure that you respect the minimum required distances for the product installation as follows: a) 25 cm from the side wall b) 50 cm from the ceiling c) The product must be installed at a minimum distance of 1 metre from the wall. Follow the assembly instructions to install the appliance. 1) Link together the various tubes provided as shown in the image.
4) Attach the handle to the back of the stand. 5) To secure the base, screw the fixing plates onto the stand base and then onto a stable surface. HOW TO USE THE CARBON FIBER HEATER Connect the power cord to a suitable electric socket (220-240V~/50Hz). The image below shows the appliance's on/off switch. When the switch is on ( I ), the unit will turn on; when the switch is on ( O ), the unit will turn off. Although the product is water-resistant, do not use it when it is raining or in wet conditions.
INFORMATION ON THE CORRECT DISPOSAL OF THE PRODUCT pursuant to EUROPEAN DIRECTIVE 2012/19/EU FOR THE DISPOSAL OF WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT” . At the end of its useful life, this appliance must not be disposed of together with household waste. We call your attention to the crucial role played by the consumer in the reuse, recycling and other forms of recovery of such waste.