EN WALL CERAMIC FAN HEATER OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. Ensure that the mains power complies with the voltage specified on the fan heater ’s data plate (220-240V~/50Hz). This heater has been projected in order to install it on the wall, you should keep 1,8 m from the floor and at least 25 cm from the two sides of the wall. Do not put it on the floor.
The appliance heats up slightly when in use. In order to avoid burns, do not let bare skin touch hot surfaces. Ensure that all objects are at least 1 meter from the front and sides of the appliance. Disconnect the mains power when the appliance is not used or for cleaning operations. Avoid using the fan heater in dusty environments or in the presence of inflammable vapours (e.g. in workshops or garages) or paint vapours. Do not place anything on the appliance, use the appliance to dry clothing.
Do not immerse the cord, plug or any other element of the appliance in water or other liquids. Do not touch the plug with wet hands. Do not place the fan heater above or near another heat source. WARNING: AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING. The symbol below signals the above warning: The fan heater may cause the risk of fire if, while in operation, is covered by or comes into contact with inflammable material including curtains, drapery, blankets, etc.
DESCRIPTION OF PARTS 1 2 3 7.Remote control 5 4 6 1. Air inlet grille 2. LED display 3. Air outlet grille 4. Horizontal flap 5. TIMER button (TIMER OFF) 6. ON/OFF and selection button INSTALLATION INSTRUCTIONS The fan heater must be installed on a wall before operating. Don’t try to use it without installation. The installation sequence of the fan heater is as follows: 1. Find a space to install the fan heater (See Figure 1). 2.
CONTROL PANEL AND LED DISPLAY ON THE UNIT COMFORT MODE (LED C + E both on): maximum heating power (2000W) ECO MODE (LED E on): Energy saving (1000 W) LED TIMER LED ROOM TEMPERATURE LED °C TEMPERATURE TIMER BUTTON ON/OFF AND SELECTION BUTTON LED FAN MODE LED FLAP AUTO SWING ON REMOTE CONTROL ON/OFF button ECO/COMFORT button - mode selection CANC buttontemperature setting cancellation TIMER button SWING button Flap auto swing on buttons Temperature adjustment The remote control uses Lithium/Manga
Information for correct disposal of the battery in accordance with the European Directive 2006/66/EC Please replace battery when its electricity charge is used up: please do not eliminate this battery together with normal household waste. It must be taken to special local community waste collection centres or to a dealer providing this service.
MAINTENANCE AND STORAGE ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE. IMPORTANT: DO NOT SUBMERGE THE CERAMIC FAN HEATER IN WATER Cleaning the outside surface of the appliance Turn the switch off and unplug before carrying out any maintenance work or moving the appliance. Use a soft cloth to remove any dust from the fan heater. If the fan heater is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower than 50°C.
