Arecont Vision HSG2 Installation Manual 0|P a g e
Arecont Vision HSG2 Installation Manual HSG2 Installation Manual Inside the box: A. B. C. D. E. F. G. 2. Arecont Vision HSG2 Housing Flat washer Spring washer Machine screw Two (2) rubber plugs RJ45 Cable Two-sided hexagonal wrench Open the HSG2 housing by using the provided wrench to loosen the two screws shown in Image 2. NOTE: Do not remove screws from the housing. Not included but needed: • #1 Phillips head screwdriver Image 2 A 3.
Arecont Vision HSG2 Installation Manual Image 5 6. Image 4-1 Screw Tray Remove the silicone cap from the housing, cut the side part (if necessary) (Image 6) to run the RJ45 cable, external power and digital in/out cables through the silicone cap. Insert the provided rubber plugs to cover unnecessary holes in the silicone cap (Image 7) Flat Washer Spring Washer Image 6 Rubber Plug Image 4-2 5.
Arecont Vision HSG2 Installation Manual DC12V Input Power Source Switchwer PoE Data Input PoE Data Output Image 9 7. Run Ethernet cable, external power cable (if necessary) and digital in/out cables (if necessary) through the hole of HSG2 housing and tighten all fittings to ensure a liquid-tight seal. (Image 8) 9. Use the provided RJ45 cable to connect ® Arevont Vision’s MegaVide camera to the HSG2 PoE data output. (Image 9) 10. Switch HSG2 power source to PoE power shown in Image 9.
Arecont Vision HSG2 Installation Manual HSG2 Wall Mount (HSG2-WMT) Installation Instructions Inside the box: A. B. C. Wall mount Pack of four (4) wood screws and four (4) dry wall anchors Two-sided Hexagonal Wrench Not included but needed: • #2 Phillips head screwdriver B C Image 11 A Image 10 1. Remove wall mount and hardware from the box. 2. Run the Ethernet cable and outside power cable (if necessary) through the wall mount. 3. Install the HSG2 housing onto wall mount as shown in image 11.
Arecont Vision HSG2 Installation Manual HSG2 Junction Box Adapter (SV-JBA) for MD-WMT2 Installation Instruction Caution: Use of SV-JBA is recommended for outdoor installation on hard surfaces requiring external conduit. Inside the box: A. B. C. D. E.
Arecont Vision HSG2 Installation Manual HSG2 Pole Mount Adapter (MD-PMA) Installation Instructions Inside the box: A. B. C. D. E. Pole Mount Adapter 2x Compression Fittings 2x Small Steel Straps 2x Large Steel Straps Pack of four (4) machine screws 4. Attach the wall mount to pole mount adapter as shown in Image 16. 5. Use the supplied two large or small steel straps to attach the pole mount adapter to the pole and tighten the compression screws as shown in Image 16. 6.
Arecont Vision HSG2 Installation Manual HSG2 Corner Mount Adapter (MD-CRMA) Installation Instructions Inside the box: A. B. C. D. Corner Mount Adapter 2x Compression Fittings Pack of four (4) machine screws 2x Packs of four (4) wood screws and four (4) dry wall anchors 3. Run the Ethernet cable and outside power cable (if necessary) through the compression fittings. 4. Attach Wall Mount Adapter to Corner Mount Adapter as shown in Image 19.
Arecont Vision HSG2 Installation Manual 8|P a g e