Instructions / Assembly

10
www.AQUASUREUSA.com
818 N Mountain Ave #203c, Upland, CA 91786 | 800.661.0680 | support@aquasureusa.com
IMPORTANT! Locate and test the main water supply valve to the house before installing the system.
If the main water supply valve fails to shut off the water completely during the test, we recommend
contacting your local plumber to xed the valve before begin installing the system.
Scan QR Code Here to get support Faster! Feel free to contact our support at
1-800-661-0680 during our normal business hour of Monday - Friday from 8:30 am
to 5:30 pm PDT. You can also email us at support@aquasureusa.com or visit us on the
web at http://www.aquasureusa.com/support for installation assistant or support.
STEP 1. Feed Water Adapter Installation
Locating the Cold Water Supply Valve:
1. Locate the Cold water supply valve under the kitchen sink. Turn off the incoming cold water completely
by turning the shut-off handle clockwise.
2. Test to see if the cold water line is completely shut off by turning on the faucet in the cold water
position. If cold water cannot be turned off, the main water supply to the house must be shut off for the
installation.
Connecting with Flex Line Riser: (See Diagram
D-1)
1. Loosen the nut and separate cold water riser
tube from faucet shank. Gently bent riser tube
so that the feed water adapter ts onto the
faucet shank.
2. Attached the feed water adapter to cold water
supply valve.
3. Attached the cold water riser to the other side
of the feed water adapter. (If necessary, apply 3
to 5 rounds of Teon tape onto the feed water
adapter before attaching the cold water riser.)
Dia. D-1
INSTALLING THE SYSTEM
Cold Water Lin
e
Shut-off Valve
F
eed Water
Adapter
Riser Tube
WARNING! Do not proceed with the installation until you have gone over the System Operation
Parameters and Installation Checklist section on page 4 of this owners manual and comply with all
the conditions listed in that section. Failure to comply may result in property damage and your system
warranty will be voided due to non-compliance with the operation parameters.