User Manual

APPLIED TECHNOLOGY SOLUTIONS, INC.
Document: FCC1225manual.wpd issued: jan99 revised:(original) page: 9
SECTION FOUR
MAINTENANCE
4.0 TROUBLESHOOTING
When supplied with power, the top panel PWR LED should light. If the PWR LED blinks, the
battery is low and must be replaced or recharged. If the PWR LED does not illuminate at all, verify LED operation
by keying the transmitter and verifying the TX indicator lights. If the TX LED does not illuminate, attach different
battery pack and retry. If the LED still does not illuminate return the unit for repair.
If the unit will not descramble the signal from another unit :
a. Insure that both units are set to the same channel operation.
b. Insure that both units are set to the same code setting.
NOTE:
Both units must be operating with the same code to achieve communications. Field
personnel will not be able to verify the actual codes associated with common or private
operation. If necessary, the issuing office should re-load the codes or return the units to
ATS.
c. Verify that the antenna is properly connected to the antenna jack.
d. Return the unit to the factory for repair.
4.1 MAINTENANCE
The Model 1225 is designed for simple installation and use. There are no user maintenance
requirements.
4.2 REPAIRS
Repairs to the Model 1225 should be performed by an authorized factory representative.