User Manual

6
A. Soldering Iron
1. Install solder wire to the solder iron holder. (Figure 1)
2. Attach the soldering iron cord assembly to the 6-pin output at the
lower center area of the main unit.
3. Place soldering iron to the soldering iron stand as shown in
Figure 1.
B. Hot Air Gun
The Hot Air gun holder was installed on the station upside down for
packaging purpose. To set up the Hot Air Gun holder, loosen the
screw that holds it on the left side of the station. After loosening both
screws, turn the holder ride side up, then tighten the screws back.
Place the hot air gun in the sensor controlled holder to prepare for
usage.
C. DC Power Supply
Connect the mobile phone power supply connecting wires to the DC
output correctly. Follow positive and negative positioning.
Figure 1. Soldering Iron stand with solder wire holder
ASSEMBLY AND PREPARATION
7
1 — Airflow gauge
2 — Hot air gun temperature adjustment button
3 — Hot air gun airflow adjustment button
4 — Automation time adjustment button
5 — Soldering iron temperature adjustment button
6 — Hot air gun connecting outlet
7 — DC output
8 — Soldering iron 5-pin receptacle
9 — DC voltage supply control knob
10 — Digital display of hot air gun set temperature
11 — Hot air gun function switch
12 — Digital display of airflow / actual hot air gun temperature
13 — Automate hot air reworking
14 — Automation time left (countdown)
15 — Soldering iron function switch
16 — Soldering iron temperature (actual and set)
17 — Voltage supply function button
18 — DC voltage supply display
19 — Reset button for all settings
20 — Current supply display
21 — Main power switch
PANEL GUIDE
- actual temperature
- set temperature
- cooling down
- sleep and off mode
- actual airflow
- airflow being set
1
2
3
4
5
6
7 8 9
10
11
12
13
14
15
16
20
17
19
18
21