Instructions / Assembly

9. Attach both female parts of the Guide Rail Brackets (08) to their male counterparts on the wall. Adjust the set screws on the Guide Rail Brackets
until they are tight and fully secure the Upper Guide Rail between the walls.
10. Gently set the Guide Block (12) on the floor, parallel to the Stationary Glass Panel flush with the vertical edge of the glass. Take time to measure
the distance from the outer surface of the glass to the center line of the guide block is 2 3/16”. Firmly hold it in place and mark hole positions on the
floor. Set the block aside and drill the holes in the floor.
Attach the anchors then use the Countersunk Screw ST4.2x30 (16) to secure it to the floor.
GUIDE RAILS
2
3
6
"
Mark holes
A
DETAIL A