User Manual

To [Destination] Section
This section is meant to receive audio from the channels represented in the From [Input Source]
section. Note that some input channels are already pre-routed to certain destinations.
Line Output
Line outputs are located on your hardware via D-Sub 25 pin connectors (TASCAM Standard Pin
Layout). Each D-Sub connector has 8 mono channels. These are represented by the LINE OUT row.
Depending on your product, you may have between 8/16/32 Line Output channels.
Headphone Outputs [HP 1 & HP 2]
Headphone outputs are marked as HP 1 & HP 2 on the bottom row of the Routing Matrix. On your
hardware, they represent ¼ TRS output connectors marked with headphone icons.
Monitor Outputs
Monitor outputs are marked as MONITOR 1 & 2 on the bottom row of the Routing Matrix. Note that
this is the Main Monitor output, located on ¼ TRS Connectors on your device’s back panel.
ReAmp Outputs
2 mono ReAmp outputs let you send recorded signal at a level suitable for re-amping through your
favourite guitar amplifiers and other gear.
TB REC
When your interface is connected via Thunderbolt, TB REC handles all computer audio input channels.
This is where you send audio input to your DAW for recording. The number of TB REC channels
represents the inputs your DAW will recognize upon startup. Depending on your product, you may
have between 32/64 Tracks of TB Recording Channels.
USB REC
When your interface is connected over USB, USB REC handles all computer audio input channels.
This is where you send audio input to your DAW for recording. The number of USB REC channels
represents the inputs your DAW will recognize upon startup.
Depending on your product you may have between 24 / 32 USB 2 0 and 64 Tracks USB 3.0 recording
channels.
HDX OUT
When your interface is connected over HDX, HDX OUT handles all computer audio output channels.
This is where you can route audio coming from your DAW for mixing, processing, recording, etc.
ADAT OUT
This row lets you route up to 16 channels of optical audio to your device’s ADAT outputs (2 ports, 8
channels each). Note that ADAT runs on SMUX.
S/PDIF OUT
This row lets you route audio to S/PDIF-compliant gear over coaxial RCA cable.
MADI 1 & 2 OUT
Lets you output up to 128 audio channels over MADI.