User Manual

Zen Tour Synergy Core User Manual 49
Among everything else it does, the Zen Tour Synergy Core rocks! A suite of 11 guitar amps
and matching cabinets lets you monitor and record the roar of your electric guitar in real-
time. There’s a bass rig in there too, so plug-in and get slappin’! If you don’t play guitar, but
like the sound of cooked-up tubes and speaker cabinets pushing air, route any audio into
these bad boys and check what happens!
Getting Started
Guitar amps and cabs are used like almost any other Synergy Core effect. Here are the
basics:
1. Connect your electric guitar or bass to one of the four instrument/line inputs on the
device’s front panel using a standard 1/4-inch TS instrument cable.
2. Open the Control Panel application and head to the ‘PREAMPS’ tab. Adjust input gain as
you play the instrument, careful not to run the meter into the red.
3. Enter the ‘Routing’ tab and drag the colored number block corresponding to your
‘PREAMP’ input onto a block from the row labeled ‘AFX IN’.
4. Drag the ‘AFX OUT’ block that corresponds to your ‘AFX IN’ block (same number) onto
the output(s) you want to monitor and record from.