User manual

Z-300 FOGGER User manual

Introduction

Thank you for choosing an Z-300 Fogger. You now own a rugged and powerful state-of-the-art machine. Prior to use, we

suggest that you carefully read all of the instructions .By following the suggestions found in this user manual, you can

look forward to the reliable and satisfactory performance of your Z-300 Fogger for years to come.

Specification:

Model No. Z-300

Rating Voltage: 120V/60Hz，230V/50Hz

Power Consumption: 700W

Fuse: VDE 125V/7A, VDE 250V/3.15A

Preheating Time: 7~8min

Tank capacity: 1.5 Liter

Weight: 8.9kg

Measurement: L525XW208XH235MM

Please follow these operation and safety instructions to ensure a long and safe life

for your FOGGER

Cautions

 Do not overfill your Z-300 Fogger. Overfilling will cause the unit to clog

Danger of electric shock

 Keep this device dry

 For inside use only. Not designed for outside use

 For the 120V models, use 3-prong grounded electrical outlet only. Prior to use take care to determine that the unit

installed at the rated voltage.

 Forbid the fogger closing up to any flame, flammable and explosive substance to avoid fire and explosive.

 Always unplug your Z-300 Fogger before filling its tank.

 Keep Fogger upright



Turn off or unplug when not in use.

 This machine is not water-or splash proof. If moisture, water, or fog liquid gets inside the housing, immediately

unplug the unit and contact a service technician or your Fogger dealer before using it again.

 No user serviceable parts inside. Refer to your Fogger dealer or other qualified service personnel.

 For adult use only. Fogger must be installed out of the reach of children. Never leave the unit running unattended.

 Never aim the output at open flames.

Danger if explosion

 Never add flammable liquids of any kind (oil, gas, perfume) to the Z-300 FOGGER liquid or the fluid container.

Pay attention to all warning labels and instructions printed on the exterior of your Z-300 Fogger

 Use only high-quality liquid or suitable dealer recommended fog fluid

 Always make sure there is sufficient liquid in the Fogger liquid tank. Operating this unit without liquid may cause

permanent damage to the machine

 If your Z-300 Fogger fails to work properly, discontinue use immediately. Drain all Fogger liquid from the tank,

pack the unit securely (preferably in the original packing material), and return it to your fogger dealer for service.

 Never drink Fogger liquid. If it is ingested, call a doctor immediately. If Fogger liquid comes in contact with skin

or eyes, rinse thoroughly with water.

PAGE 1
Z-300 FOGGER User manual Introduction Thank you for choosing an Z-300 Fogger. You now own a rugged and powerful state-of-the-art machine. Prior to use, we suggest that you carefully read all of the instructions .By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your Z-300 Fogger for years to come. Specification: Model No. Z-300 Rating Voltage: 120V/60Hz，230V/50Hz Power Consumption: 700W Fuse: VDE 125V/7A, VDE 250V/3.
PAGE 2
Unpacking & Inspection Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. Your Z-300 Fogger machine should be accompanied by the following items: 1. This user manual! 2. Power cord 3. ZC-6 multi-function remote control with attached cord If any equipment is missing contact your Fogger dealer immediately. Before beginning initial setup of your Z-300 Fogger, make sure that there is no evident damage caused by transportation.
PAGE 3
fuse, remote connection, and power from the wall, if all of the above appears to be O.K., plug the unit in again if Fogger does not function after 30 seconds, discontinue operation or permanent damage to the unit may result. Return the machine to your. Fogger dealer Always drain tank before mailing or transporting this unit.