Installation Manual
Package list A Only include one kind of shower arm depend on what kind of shower system you purchase B 5 6 8 9 10 11 12 13 14 15 16 17 WARNING: Choking hazard. Please keep all small parts and plastic bags out of the reach of children.
Step 3: Drill, hammer in anchors, fasten valve body to wall (Thisstep is for masonry application. ) 1.INSTALL SHOWER VALVE Step 1 : Measure valve installation dimensions. 4X 4X 4X 11 15 16 2.45 inches Drill size: 6MM 16 0.6 inches Distance from back of valve body to finish surface to be between 2.45 to 3 inches, rubber surface cut flush to finish before triminstallation This part can be cut, so don't worry about the protruding edge after sealing the wall.
Step 6: Test for Leaks Before Installing Wall Board Step 5: Connect the water pipe. (Pipe clean and freeof impurities) Be suitable for Pex pipe, Copper pipe and PVC pipe Wrap enough teflon tape 1. Check the valve connector for leaks; 2. Open the valve and est the hot and cold water left and right: 3. Checking the Water diverter knob can correctly switch between the showerhead and handheld.
Step 7:Tile Important Note Before tiling 1X 1X 7 8 H C Finished Wall 1X 9 1X 2X 2X 10 12 13 CeramicTile EmbeddedBox 1X 14 Adiust the red collar to limit the water flow and temperature. Turn clockwise to reduce water pressure until it closes.
2.INSTALL SHOWERBRACKET Wall Mounted /Ceiling Mounted installation Before Tiling 1X Recommend using copper drop ear pipe elbow1/2"-14 NPT 4 0.4 inch 1.Wall mounted installation(Fits to A Style and C Style) 0.4 inch After tiling, the distance from the tile surface to the brass fittings (recessed the wall) is: 1: The shower bracket is 0.4 inch. 2:The shower arm is 0.4 inch. 4 0.4 inch 2.
3.INSATLL HANDHELD SHOWER HEAD AND SHOWER HOSE 4.
4.INSTALL SHOWER ARM (B STYLE) AND RAIN SHOWER HEAD Customer Name Retailer /Assembly Fitter 1X 1X 1 2 Purchase Date 1X Warranty Duration 3 5 years as of purchase date (B) 1.lf the above contents are not complete, the warranty will be considered void, please confirm 3 the above contents when you purchase. 2The complimentary repairs are limited to instances mentioned on the warranty card only. Longer thread for ceiling mount 3.
Clean and maintain product How to clean shower head nozzles 1.Just rub the nozzles with your finger or a toothbrush to loosen any deposits, and then run hot water for a few minutes. 2.Put the showerhead into a pot. Consider using a smaller container that just about fits the showerhead; this way, you will use less vinegar. You can also use a small bucket or plastic bin.