Installation Guide

ASSEMBLY INSTRUCTIONS
1- Cut tubing to desired length. Make sure all burrs are removed and ends are cut square.
2- Slide nut on tube. Threaded end “A” of nut must face out.
3- Flare end of tube with a 45
0
flaring tool.
a-Measure flare diameter.
b- Examine flare for excessive thin out.
4- Lubricate threads and assemble to fitting body. Nut should be turned hand tight.
5- Tighten assembly with wrench until a solid feeling is encountered. From that point, apply a one-sixth turn.
Note: Do not over-torque as it may damage the fitting or split the tubing at the flare.
3145 N Oak St Kansas City, MO 64111 || Oice: 800-821-5725 || Fax: [phone]