Installation Guide

3
INSTALLATION
PREPARATION
2
a
b
1. Most homeowners prefer to have the storm
door handle on the same side as the entry door
handle. In shallow door openings, this can cause
the two handles to interfere. Check for potential
interference using the rough measurements. If you
anticipate that there will be interference, purchase
a storm door that is hinged on the opposite side of
your entry door. See page 2, Figure 3 for detailed
hardware depth requirements.
In this step, you will conrm that your storm door hinges on the correct side.
1. Left Handed (Figure 4): From the exterior, a left handed storm door will have the handle on
the left side of the storm door. See pages 4-10 for installation instructions.
2. Right Handed (Figure 5): From the exterior, a right handed storm door will have the handle
on the right side of the storm door. See pages 11-17 for installation instructions.
3. The interior is the side the insect screen or glass panel is installed (Figure 6).
Figure 4 Figure 5
2 1/2”
40 1/2”
c
1. Supporting weight of door by door frame, remove
door from carton and remove tape holding insect
screen to door frame.
2. Remove insect screen by tilting it back and then
liting it away from shipping clip, then remove and
properly discard shipping clip.
3. With door standing, ensure latch rail is properly
seated in orange spacer clips (G), then ensure
bottom spacer (H) is attached to bottom of door
and slid toward handle side.
NOTE: See troubleshooting section at end of install
guide if bottom spacer becomes detached.
M
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
Tools needed:
1/2”
x 3
LEFT HANDED
A LA IZQUIERDA
À MAIN GAUCHE
RIGHT HANDED
A LA DERECHA
À MAIN DROITE
Figure 6
X
VIEW
i
VIEW
X
VIEW
TO DOOR SILL
HASTA EL BATIENTE DE LA PUERTA
JUSQU’AU SEUIL DE LA PORTE
H
G
#8
#10
#12
#6
3/4” Machine Pan Painted
1/2” SMS Pan
1/2” SMS Pan Painted
1/2” SMS Flathead
1/2” Self-Drill Pan
1/2” Self-Drill Pan Painted
3/4” Machine Flathead
7/8” Machine Pan Painted
1” SMS Pan
1” SMS Pan Painted
1” Machine Pan Painted
1-1/2” Machine Flathead
1-1/2” Machine Flathead
2” SMS Pan Painted
5/8” SMS Pan Painted
1-1/4” SMS Pan