Use and Care Manual

1. Turn on both, cold-water supply and undersink feed-water valve,

but close the tank ball valve. If any leaks are noted, turn off supply

and correct before proceeding.

2. Check system for leaks; tighten when necessary.

3. Open RO faucet and keep it in ON position.

4. After 5 minutes, the water will start to drip out of the RO faucet.

Let it drip for about 10 minutes and then close the faucet. Turn on

the tank ball valve. It will take several hours (2-3) for the storage

tank to fill, depending on the local water pressure.

DO NOT DRINK THE WATER FROM THE FIRST TANK

PRODUCED BY YOUR NEWLY PURCHASED SYSTEM.

5. After the tank is full (you will hear the water stop), flush the system

by placing the RO faucet in the open position until the water is

completely discharged.

6. Upon complete discharge of storage tank, close the RO faucet and

let the refilling process begin. This process could take 2-3 hours to

complete.

7. After the second tank is filled, you may enjoy the pure water.

8. Check for leaks daily during the first week of use and periodically

thereafter.

9. You may notice that the water may be milky colored during the

first week. This is an indication of air bubbles in the water; it is

normal and safe.

System Start-Up