Specifications

NetLinx Security with a Terminal Connection
149
NetLinx Security - Terminal
Option 12 - Display Telnet Timeout in seconds
This feature is disabled after the installation of firmware build 130 or higher onto your target
Master.
1. Type 12 and <Enter> at the Security Setup prompt (at the bottom of the Main Security Menu)
to view the current Telnet Timeout value (in seconds). A sample session response is:
Telnet Timeout is 10 seconds.
2. Press <Enter> to return to the Security Setup Menu.
Option 13 - Make changes permanent by saving to flash
When changes are made to the security settings of the Master, they are initially only changed in
RAM and are not automatically saved permanently into flash. This selection saved the current
security settings into flash. Also, if you attempt to exit the Main Security Menu and the security
settings have changed but not made permanent, you will be prompted to save the settings at that
time.
Type 13 and <Enter> at the Security Setup prompt to (permanently) save all changes to flash.
Changes made to the target Master from within the Terminal window are not reflected
within the web browser, until the Master is rebooted and the web browser connection
is refreshed.
Any changes made to the Master, from within the web browser are instantly reflected
within the Terminal session without the need to reboot.