Product specifications

Displaying Stream Content
75
MAX-CSE/MAX-CSD10 Operation/Reference Guide
Establishing the Final Connection Between the Two Units
1.
Start playing the media at its source (DVD, VCR, camera, etc.).
2. While in the UI pages (log back in if not already connected), navigate to the Administration page by
clicking on the Admin link from the left Navigation frame.
3. Locate the Mode section of this page and click the Play button to begin streaming the incoming
media content to the targeted Modero panel. For these procedures, the Program information is
optional and not "picked-up" by the panel.
4. With the panel now loaded with the new TPD4 project containing the streaming media
page/popup/button, navigate from the initially displayed (main) page to the page containing the
Streaming Video Fill button which we created in the previous step. It should now be displaying the
audio and video from the incoming stream.
If the audio level is not sufficient, you can either go back and create a volume control button
or go to the Modero’s Audio firmware page and adjust the value assigned to the Master
Volume for the panel.
If no video is being displayed on the page:
Navigate to the firmware pages by pressing the grey Front Setup Access button for
3 seconds to open the Setup page and then press the on-screen Video Adjustment
button, causing an option bar to slide outwards from the Navigation buttons.
Click on the Streaming Adjustment button to launch the Streaming Video Adjustment
page and confirm that the panel is at least receiving the signal (FIG. 47).
If there is no signal displayed, return to the MAX-CSE UI pages and from the Encoder
Profiles page, confirm that the correct panel IP Address and target port where entered
into the Streaming Source field within the TPDesign4 project.
If this still doesn’t produce a displayed signal, cycle the Play/Stop buttons and verify that
both the encoding Status says Streaming (verifying that the process of encoding is
underway) and that the unit is detecting an incoming signal (shown by the word SYNC
appearing in the Video Sync section of the UI).
The most common error can result from a bad cable not being detected and therefore no
signal becomes available for the unit to encode. The encoding process can continue on a
MAX-CSE even without an actual signal being detected.
FIG. 47 Video Adjustment page (showing default values)
Incoming Video signal
Once done making your screen
adjustments, SAVE THE SETTINGS.