User's Manual

Registering without remote control
If there is no transmitter registered to the receiver, you should see an OSD menu on the monitor.
1. Connect the HD Source to the Amimon-AMN36254_PR2 transmitter.
2. Connect a HD-SDI cable from the Amimon-AMN36254_PR2 receiver to the HD display*.
3. Turn on the transmitter and receiver.
4. Long press the Registration button [#18] on the Rx.
5. The message “Please Activate the Registration on Transmitter Unit” will appear on the
monitor.
6. Press the Registration button [#5] on the Tx until the “Network” LED starts blinking.
7. Wait for OSD message of "Adding [Tx name] Press OK to continue or Exit to cancel".
8. Press the Registration button [#18] on the Rx to confirm.
9. Wait until the registration process is complete. An OSD message of " Adding [Tx name]…"and
progress bar will appear during the process.
10. Video link is established.
*The registration process can be done without HD source, an OSD message will appear to notify of
missing video source.
Registering a transmitter to multiple receivers
The Amimon - AMN35223_PB transmitter has the ability to connect up to 4 receivers at a time.
1. There is a need to make sure the transmitter is not transmitting video to other receivers, so all
other receivers which are registered to the transmitter should be powered down while
registering an additional receiver.
2. *Connect the HD Source to the Amimon - AMN35223_PB transmitter.
3. Using HD-SDI cables connect each Amimon-AMN36254_PR2 receiver to a HD display.
4. Power on the transmitter and receiver.
5. Power on only one receiver at a time for ease of installation.
6. Use the remote control at the Amimon-AMN36254_PR2 receiver and
Press the “Add” Hotkey button.
7. The message “Please Activate the Registration on Transmitter Unit” will appear on the
monitor.
8. Pressing the registration button on the transmitter until the “Network” LED starts blinking.
9. Wait for OSD message of "Adding [ Tx name ] Press OK to continue or Exit to cancel".
10. Press the “OK” button on the IR Remote to confirm the addition of the receiver.
11. Wait until the registration process is complete. An OSD message of " Adding [ Tx
name ]…"and progress bar will appear during the process.
12. In order to add additional receivers to the transmitter, Power down all other Amimon-
AMN36254_PR2 receivers, except the latest one.
13. Repeat steps 5 through 12 for each receiver.