Instructions

BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL AMXFLIGHT AFX-105
28
TROUBLE SHOOTING GUIDE
Problem
Possible Cause
Solution
Helicopter and remote control are switched
on, LED at the tail is flashing, no function.
Helicopter and remote control are not
connected.
Reconnect the helicopter and the remote
control.
Nothing happens when the helicopter is
switched on.
Flight battery is empty. Check the voltage of
the battery.
Batteries on the remote control are empty.
Remote control is off.
Charge the battery
Replace the transmitter batteries.
Switch on the remote control.
The engine does not turn when the throttle is
opened, the LED on the receiver flashes.
The battery is empty.
The battery is not inserted correctly.
Charge the battery.
Insert the battery correctly.
The rotor turns but the helicopter does not
take off.
The battery is empty.
Charge the battery
The helicopter vibrates very strongly.
The rotor blades are deformed.
The shaft is bent.
The tail rotor is bent.
The shaft of the tail motor is bent.
The screws on the rotor blade mounts are too
tight.
Replace the rotor blades.
Replace the shaft.
Replace the tail rotor.
Replace the tail motor.
Loosen the screws on the main rotors.
The helicopter turns to the left after takeoff.
The tail motor has too little power.
The tail rotor is defective.
The tail motor is defective.
Check the connection of the tail motor and
the tail rotor. If they are defective, replace
them.
The helicopter drifts in one direction.
The servos must be trimmed.
Trim on the remote control as described in the
instructions.
The helicopter does not fly in all directions.
Servo defective
Replace the defective servo.
SPARE PARTS
You can find a spare parts list at amewi.com