Installation Sheet

21 Place the sweep back onto the bottom of
the door. Step inside the shower and close the door.
Mark on the sweep at the edge of the polycarbonate
strike jamb.
Open the door and remove the sweep. Trim the
deflector lip and the inside portion of the sweep.
Replace the sweep and close the door. Check for
clearance. The lip of the strike jamb should touch
the glass not the sweep. (see illustration)
22 Carefully silicone the seam between the walls
and the wall jambs as well as the curb and threshold
on the inside of the shower.
NOTE: Silicone on the exterior seam is optional.
DO NOT USE the shower until the silicone is
completely cured. Check the tube of silicone
for the manufacturer recommended cure time.
(typically 24 - 48 hours)
NOTE: Do not silicone over the weep holes
SILICONE
EXTERIOR
INTERIOR
QCI5239 Rev 0 Page 10 Certified 06/20/2016