Installation Guide

710284-100 Rev. G 11/16
5
FITTING FRAME ASSEMBLY INTO OPENING
2 PEOPLE REQUIRED
(11) Screw
M4x12
(6) Wall Post
(15) Door Post
4A
4B
VIEW FROM INSIDE
(9) Center Guide
VIEW FROM INSIDE
Slide Wall Posts (5) on each end. The Wall Posts
fit inside Door Posts of the frame.
Attach Center Guide (9) to Bottom Horizontal Rail using
screw as shown in 5A.
Use the hole closest to side that will have Fixed Glass Panel (17).
Fill the remaining hole with silicone sealant. Insert Center Guide
Spacer (10) as shown in 5B.
4A - 4B
5B
5A
1
2 3
ANCHOR INSTALL
Mark holes
DO NOT install screws
Use 1/4" drill bit
for anchor holes
DRILL FOR ANCHOR
IF NEEDED
INSTALL ANCHOR
IF NEEDED
Place completed frame onto the shower edge located at the edge
of the at surface of the deck. Push wall posts against wall and
position the posts with a level and mark the mounting holes on the
wall. Remove the frame.
Use the anchors if NOT securing to studs.
Remove frame and proceed to STEP 3.
A
ASSEMBLE FRAME (CONTINUED)
The Center Guide should be xed on the hole
which is closest to the xed panel, the unused hole
should be lled with silicone.
5A - 5B
(10) Center Guide
Spacer
1
2
57-1/4" x 58-1/16"
(1455 x 1475mm)
1
2
3
A