Installation Guide

2
770278-100 Rev. 1 05/2020
Wall Preparation For Vanity Installation
Provide suitable reinforcement behind nished wall for vanities mounting cleat. Vanity must be mounted to a solid wall
surface behind the wall.
Note: If replacing an existing sink be certain to shut off water supply prior to removing old sink.
Remove sliding drawers which will allow easier access to installation of vanity by pushing grey plastic tabs outwards
releasing from drawer tracks, then gently pull drawer up and out for each drawer.
Removing Vanity Drawers
1
2
Remove screws holding wall mounted cleat to vanity. Also remove cleat from the optional Bridge if being used.
Note: If installing optional legs to vanity or optional Bridge, proceed to procedures below for: Installing Optional Legs.
Removing Cleat Screws
3
Strike a “level line” on wall where top of cleat will be installed. If optional legs are used, ensure placement of cleat accounts
for overall height of vanity and legs when assembled together.
Mark Wall
4
C/L of 2 x 6
Support and
Bracket
Finished Floor
Water Supply Lines
Drain