Installation Guide

- 2 -
2
M965830 (6/17)
MAKE WATER SUPPLY CONNECTIONS
LOOP SUPPLIES
IF REQUIRED
28"
1
2
COLD
COLD
HOT
HOT
Figure A.
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies.
Connection on tting supplies are 3/8" compression.
Connectleft supply to Hot and right supply to the Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
• Faucet supplies are 28" long from faucet base.
Note: If additional supply length is required,
installer must purchase additional parts separately.
Important: If SUPPLY HOSES (1, 2) are
too long, loop as illustrated to avoid kinking.
Figure A.
PUTTY
2
1
3
4
5
3
DRAIN INSTALLATION
• Apply a bead of PUTTY to underside of DRAIN BODY
FLANGE (1).
• Feed DRAIN BODY (1) down through lavatory.
• Assembly GASKET (2) WASHER (3) and LOCKNUT (4)
onto DRAIN BODY (1). Tighten LOCKNUT (4) rmly.
• Assembly TAILPIECE (5) to DRAIN BODY (1).