Installation Sheet

- 3 -
M965781 Rev. 1.0 (1/18)
• With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
• Remove AERATOR (3).
• Operate HANDLE (1) to ush water lines thoroughly.
• Replace AERATOR (3).
TEST INSTALLED FITTING
4
1
3
OFF
ON
“P” TRAP
WASTE
OUTLET
2
2
HOT
COLD
5
6
• To remove or replace cartridge:
– Turn valve to OFF position.
– Pull out PLUG BUTTON (1) and remove HANDLE SCREW (2).
– Pull off HANDLE ASSEMBLY (3).
– Unthread CARTRIDGE NUT (5) using a 7/8" socket (deep socket)
and remove.
– Pull out CARTRIDGE (6).
– Inspect CARTRIDGE (6) and O-RINGS (7) for debris and
clean if necessary.
– Clean MANIFOLD (8) and rinse clean.
– Reinstall CARTRIDGE (6) and O-RINGS (7) onto
MANIFOLD (8).
– Reinstall CARTRIDGE NUT (5) and CAP (4) (orientation of the
cap is very important).
– When reinstalling the HANDLE (3) push the lower gear back
(as shown in the gure) then install HANDLE (3) in pushed down
position (make sure the seal alligns with the body).
– Push SEAL (4) down, ensuring that it is completely pushed into
the spout body.
– Reinstall HANDLE SCREW (2) and PLUG BUTTON (1).
SERVICE
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
CAUTION
Turn off hot and cold water
supplies before beginning.
8
5
6
REMOVE
INSTALL
7
10
4
1
2
2.5mm HEX KEY
3
LOWER GEAR