Installation Guide

Product names listed herein are trademarks of AS America, Inc.

M985014 (3/19)

Contemporary

Wall-Mount Pot Filler

Adjustable Wrench Teon Tape Phillips Screwdriver Electric Drill3/8” Hex Wrench

6-1/8"

(155 mm)

3-3/16"

(81 mm)

1-7/8"

(48 mm)

INLET

1/2" NPT

(21 mm)

2" (51 mm)

11"

(280 mm)

3-15/16"

(100 mm)

2-3/4"

(70 mm)

3-1/4"

(82 mm)

Thank you for selecting American Standard...

the benchmark of ﬁne quality for over 140 years.

To ensure that your installation proceeds smoothly-please

read these instructions carefully before you begin.

INSTALLATION

INSTRUCTIONS

4803900

Certied to comply with ANSI A112.18.1M

RECOMMENDED TOOLS AND MATERIALS

Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing

supply stores. It is essential that the tools and materials be on hand before work is begun.

ROUGHING-IN DIMENSIONS:

• For reference

- 1 -

PAGE 1
INSTALLATION INSTRUCTIONS 4803900 Contemporary® Wall-Mount Pot Filler Thank you for selecting American Standard... the benchmark of fine quality for over 140 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M RECOMMENDED TOOLS AND MATERIALS Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing supply stores.
PAGE 2
1 ROUGHING-IN CAUTION Turn off hot and cold water supplies before beginning. • Install a 2x6 Cross Brace within the wall between the Wall Studs. • Determine the supply height from the finished floor and drill a 7/8 inch dia. hole at that location. FINISHED WALL 16" WALL STUDS 7/8"DIA. HOLE DRILL 7/8" DIA. HOLE 2X6 CROSS BRACE 2X6 CROSS BRACE FINISHED WALL OPTIONAL TO FINISHED FLOOR WALL BOARD 2 INSTALL COLD WATER SUPPLY • Install the 1/2" NPT cold water supply.
PAGE 3
INSTALL FAUCET MOUNTING ADAPTER FINISHED WALL WALL BOARD • Apply Sealing Tape to the threads of the Supply Nipple. Figure A. • Thread the MOUNTING ADAPTER (1) onto the Supply SUPPLY NIPPLE Nipple until tight against the the finished wall. Use a 3/8 Hex Wrench. Figure B. Figure A. SEALING TAPE 1 3/8" HEX WRENCH SUPPLY NIPPLE Figure B. 4 INSTALL POT FILLER 3 3/8" HEX WRENCH • Install the ESCUTCHEON (1) onto the pot filler body.