Installation Sheet

OWNERS MANUAL
24
TROUBLE SHOOTING GUIDELINES
Whirlpool Pump
Motor Will Not Start – Check For:
 Check the air line between the motor and air button for connection and depress to test air signal.
 Improper or loose connections, open switches or relays, blown circuit breakers.
 Manually check rotation of motor shaft for free movement and obstruction.
Motor Cuts Out – Check For:
 Wiring, loose connections etc.
 Low Voltage at motor. (Frequently caused by undersized wiring.)
 Binding or overload. (Amperage Reading.)
Motor Hums, But Will Not Prime. –Check For:
 Make sure all suction, discharge lines and valves are open and un-obstructed.
 Check for correct water level.
 Block off suction and determine if pumps develops a vacuum. If pump develops a vacuum check
discharge line for obstruction or a leak in the suction line.
 If the pump does not develop a vacuum and the pump has the correct water level, check for proper
voltage and / or check the pump wet end for clogging or debris.
Air Massage
Motor Will Not Start – Check For:
 Check the air line between the motor and air button for connection and depress to test air signal.
 Improper or loose connections, open switches or relays, blown circuit breakers.
 Manually check rotation of motor shaft for free movement and obstruction.
Motor Cuts Out – Check For:
 Verify if the air supply line from the blower to the manifold is connected and not obstructed.
 Wiring, loose connections etc.
 Low Voltage at motor. (Frequently caused by undersized wiring.)
Chromatherapy Lights
Lights Will Not Operate – Check For:
 Check the air line between the control box and air button for connection and depress to test air
signal.
 Wiring and /or loose connections etc
 Improper or loose connections, open switches or relays, blown circuit breakers.