Installation Guide

OWNERS MANUAL
19
SAVE THESE INSTRUCTIONS!
OPERATING INSTRUCTIONS
1. Enter your American Standard® walk-in bath, close the door, place handle in down position, and fill
the bath to at least 2 inches above the highest jet before activating the whirlpool pump (if equipped).
Do not apply excessive pressure when placing the handle in the close position. Do not put weight
on the door when entering and exiting the tub. It is recommended to leave the door in the open
position when the tub is not in use.
2. If your American Standard® walk-in bath is equipped with Whirlpool Jets, Air Spa, or Combo system,
the pump or blower is operated by the push button switch labeled “Jets” or “Air”. Both the number of
buttons and their assorted functions vary. Do not depress the button(s) repeatedly and/or rapidly as all
function(s) are controlled electronically. It may take a few seconds before any change becomes
perceptible. Refer to massage instructions sheet for more information on the controls.
3. If your American Standard ® walk-in bath is equipped with whirlpool jets, you can adjust the
direction and flow rate of the jets to your liking by moving the nozzle for direction and turning the
outside ring or the nozzle clockwise or counterclockwise for the flow rate. Some jets are not
adjustable at the jet face, but can be adjusted by the “Legs Only Massage” valve located near the seat.
(If equipped.)
4. The Legs Only Massage (whirlpool & combo systems only) opens and closes the jets above the seat
which allows you to fill the tub half-way and operate only the lower whirlpool jets. The Legs Only
Massage valve must be closed when filling the tub half-way and operating the whirlpool. Failure to
close the valve, when filling the tub half-way will result in water shooting out of the jets above the seat
when the pump is activated. (If equipped.)
5. If your American Standard® walk-in bath is equipped with an Air Spa system, you can activate the
heated blower by pushing the push button on the deck. Push the button to turn on / off and cycle for
the various speeds.
6. If your American Standard® walk-in bath is equipped with an in-line heater, the heating element will
come on automatically, but only when the whirlpool system is turned on. This heater is designed to
extend the comfortable bathing time, but does not reheat the bath water.
7. If your American Standard® walk-in bath is equipped with the Automatic Tub Clean System - Ozone,
the system will turn on automatically when the whirlpool system is turned on.
8. If your American Standard® walk-in bath is equipped with the Quick Drain
TM
, this system has its own
dedicated pump, suction and switch to activate the drain. Simply open the traditional drain system
(turn the overflow) and then press the Quick Drain™ on/off switch to activate the drain. When the
water falls below the suction guard, press the control switch to turn the drain system off.