Installation Sheet

7302113-100
- 2 -
BACK-TO-BACK INSTALLATION
Recommended fitting type for
back-to-back installations.
Depending upon your plumbing and venting conditions, the flow from the Champion
®
PRO in a
back-to-back installation may create a vacuum on the system and draw water from the opposing
bowl. The National Standards Plumbing Code prohibits the use of a cross fitting for drainage as
throw over is possible. The code does approve a directional "Y" style fitting with proper venting to
direct the water downward and away from the other toilet.
Turn Off Water Supply
Flush to remove
water from tank;
sponge remaining
water from
bowl before
removing toilet.
Clean Flange
Before You Start:
If Removing An Existing Toilet
!
Caution: If leaving floor flange
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.
FINISHED
FLOOR
ROUGHING-IN DIMENSIONS: NOTE: Distance from wall to closet flange centerline must be as listed below: A = 12" (305mm)
Retrospect
®
Champion
®
PRO 2-piece Toilet 212AA Series Right Height
®
Elongated Retrospect
®
Champion
®
PRO 2-piece Toilet 212BA Series Right Height
®
Round Front
FINISHED WALL FINISHED WALL
FINISHED
FLOOR
FINISHED
FLOOR
Retrospect
®
Champion
®
PRO 2-piece Toilet 211CA Series Elongated
FINISHED WALL
18-1/2"
(470 mm)
15"
(381 mm)
30"
(762 mm)
12"
(305 mm)
9-3/8"
(238 mm)
13-13/16"
(351 mm)
30-1/4"
(768 mm)
19-3/4"
(501 mm)
10-1/2"
(267 mm)
14"
(356 mm)
9-7/16"
(240 mm)
1"
(26 mm)
3-9/16"
(90 mm)
2"
(52 mm)
18-1/2"
(470 mm)
12"
(305 mm)
16-1/2"
(419 mm)
31-1/2"
(800 mm)
9-5/16"
(237 mm)
13-13/16"
(351 mm)
19-3/4"
(501 mm)
10-1/2"
(267 mm)
14"
(356 mm)
9-7/16"
(240 mm)
1"
(26 mm)
3-9/16"
(90 mm)
2"
(52 mm)
30-1/4"
(768 mm)
16-1/2"
(419 mm)
16-1/2"
(419 mm)
31-1/2"
(800 mm)
12"
(305 mm)
9-5/16"
(237 mm)
13-7/16"
(341 mm)
19-3/4"
(501 mm)
10-9/16"
(268 mm)
14"
(356 mm)
9-7/16"
(240 mm)
1"
(26 mm)
2"
(52 mm)
3-9/16"
(90 mm)
28-1/4"
(718 mm)