Installation Instructions

- 2 -
M965854 (8/17)
1
• The ADJUSTABLE SHOWER BAR works best if secured to a wall stud or cross brace within the wall,
using the SCREWS supplied.
• If the ADJUSTABLE SHOWER BAR is to be installed on a tile or plaster wall the ANCHORS (1) and SCREWS (2)
should be used.
• Determine desired height and location (optional) and mark the top center line. Use a level to help mark the
vertical center line for the two mounting locations. The distance between the two mounting holes is 30" (765 mm).
Note: This dimension is important and must be maintained. If ESCUTCHEON is secured to a stud or cross brace
with in the wall, drill small pilot holes for SCREWS (2).
• For installations on drywall or tiled walls: Use ANCHORS (1) and SCREWS (2) for securing ESCUTCHEON
to nished wall.
• Drill two 1/4" (6 mm) dia. holes a minimum of 1-3/4" (44 mm) deep. Insert the two ANCHORS (1) flush with face of
the nished wall.
INSTALL WALL ANCHORS
30"
(765 mm)
FINISHED
WALL
LEVEL
1
FINISHED
WALL
2
2
C/L
C/L
C/L
1
30"
(765 mm)