User`s guide

Hardware
471
Supported Standard Commands
General description
The following standard SMASH-CLP commands defined by DMTF specification are supported
by the management firmware.
Command Function Privilege
cd
Move to the target.
Operator
dump
Move the dump from the memory map to the URI.
Used for saving SG Information.
Administrator
exit
Terminate the CLP session
Operator
help
Display the help menu
Operator
load
Move the binary image from the URI to the memory map.
Used for restoring SG Information and updating the firmware.
Administrator
reset
Power OFF the target compulsory.
Operator
set
Set the value to the target property.
Operator
show
Display the target property and contents such as settings for
the network or user account
Operator
start
Power ON the target
Operator
stop
Shut down OS for the target
Operator
version
Display the version of SMASH-CLP
Operator
IMPORTANT:
•The interruption of the command by CTRL + C is not
supported. However there are some exceptions.
NOTE:
•The operations for SMASH-CLP is similar to the one of Linux or
UNIX. For example, the “show”“ command is equivalent to
“ls” for Linux and UNIX. The target is equivalent to the
directory for Linux and UNIX.
•The prompt for SMASH-CLP is “->”.