Owner's Manual

c ..
Measure your dash cavity to determine depth. Use the TP-123
Flat Trim Panel for flush mounting,
EXT-123..;2 Extension Bezel
for 1/2" depth, or EXT-123, for extra 1" chassis depth.
EXB-123 .. GMB-123 To install twin shaft
mounted radios, Slide
radio in from back to
either the
TP-123, EXB-
123 or EXB';123-2
Extension Bezels.
Install FP-123 Face
Plate onto the front,
using hardware and
mounting hen snap to
GMB-123 Main
Bracket.the front, using
hardware and mounting
instructions supplied with
the radio.
,-,
", ............. ~
"
"
"),
" ,
" ,
I
,/
,. Remove Twin
Shaft Radio
Mounting
Provisions
To . install DIN E,
Removable Face or
Pullout Sleeve Mounted
Radios, break away
Twin Shaft Radio
Mounting provisions in
TP-123 Trim panel or
either EXB-123
Extension Bezel to cre-
ate a rectangular open-
. ing,
the.n snap TP-123
.onto
GMB-123 Main Bracket. Install mounting sleeve to rectangular
opening according to radio manufacturers instructions.
Side Sleeve Into l;j
Rebmgular Opening ~
and Bend Tabs To
Secure.
i. GRB-330 1\:\ If your factory radio has a rear support bumper, use
. ~.J) the GRB·330 Rear Support Bumper supplied with
~
.~. this kit by pushing or screwing onto the rear sup-
/ . port bolt (rear center of chassis) of your
new radio.
Rear Support If the rear support is in a different location, use the
Bolt Of Radio rear support strap supplied, with your radio, and
~ ...
© 1994 AMERICAN lNTERNATIONA( PACIFIC INDUSTRIES, CORP.
. .... ,. .