Use and Care Manual

Fire Pit Pan Spark Ignition Kit Assembly Instructions (Cont.)

Assembly Instructions

STEP 1 - Install Fire Pit Ring plug into the top of the fire pit ring. Gas exit

holes can be facing up or down. (FIGURE 1)

Tip! Some prefer holes up for propane and holes down for natural gas.

1. STEP 2 - Screw fire pit ring onto the Flat Pan.

(FIGURE 2)

STEP 3 - Insert the Spark Igniter Probe into the Flat Pan, and secure with the

provided screw and nut.

(FIGURE 3)

Tip! For best results, fill pan with burner media before ignition.

STEP 4 - Attach the Air Mixer Assembly to the ½” male threads on the

bottom of the pan. Be sure the stamped arrow on the Propane Air Mixer is

pointing toward the fire pit ring. The arrow indicates the direction of gas

flow. (FIGURE 4)

NOTE: For Natural Gas installations, the Propane Air Mixer is not utilized.

The Natural Gas configuration also does not use a propane regulator.

STEP 5 - Attach the Gas Hose from the exit side of the Key Valve to the

bottom of the Propane Air Mixer. The Gas Hose uses a 3/8” flared male

to ½” Female adapter (included) for connecting to the Flat Pan.

(FIGURE 5)

STEP 6 - Attach the Igniter Spark Probe Wire to the bottom of the Igniter

Spark Probe. (FIGURE 6)

FIGURE 1

FIGURE 2

FIGURE 4

FIGURE 3

FIGURE 4

FIGURE 5