User manual

Operating Modes:
• Sound-Active mode - The unit will react to sound.
• DMX control mode - This function will allow you to control each
individual fixtures traits with a standard DMX 512 controller such as
as the Elation® Show Designer™.
Sound Active Mode:
1. Plug the fixture in and put dipswitch #1 in the “ON” postion.
2. The fixture will now change via sound.
3. The optional UC3 Controller (not included) may be used to control
different functions including blackout.
Master-Slave Operation (Sound Active): This mode will allow
you to link up to 16 units together and operate without a controller.
In Master-Slave mode, the units will react to sound. In Master-Slave
operation one unit will act as the controlling unit and the others will
react to the controlling units programs. Any unit can act as a Master
or as a Slave.
1. Using standard XLR microphone cables, daisy chain your units
together via the XLR connector on the rear of the units. Remem-
ber the Male XLR connector is the input and the Female XLR
connector is the output. For longer cable runs we suggest a
terminator at the last fixture.
2. Choose a unit to function as the Master and set dipswitch #1 to
the “On” position.. This unit must be the first unit in line. Then sim-
ply daisy chain the units together using XLR cables.
3. Now set the Slave units dipswitches all to the “Off” position. Now
they should react the same as the MASTER.
4. The optional UC3 Controller (not included) may be used to control
different functions including blackout.
DMX Mode:
Operating through a DMX controller give the user the freedom to cre-
ate their own programs tailored to their own individual needs.
1. This function will allow you to control each individual fixture’s
traits with a standard Elation® DMX 512 controller.
2. The Revo I™ uses four DMX channels to operate see page 8 for
the DMX traits.
3. To run your fixture in DMX mode, plug in the fixture via the XLR
Revo I™ Operating Instructions
©American DJ Supply® - www.americandj.com - Revo I™ User Manual Page 8©American DJ Supply® - www.americandj.com - Revo I™ User Manual Page 7
Revo I™ DMX Traits
connections to any standard DMX controller. Set your desired
DMX address following the set-up specifications that come with
your DMX controller.
Revo I™ Operating Instructions
Revo I™ UC3 Control
Blackout Blackout the unit
Function 1. Synchronous Strobe Chase
2. Sound Strobe (10 Chase)
3. Two Light Strobe
Mode Sound/Strobe Chase
(LED Off) (LED On)