Manualshelf

User Manual

ManualsBrandsAmcrest ManualsElectronics4K UltraHD 8 Channel DVR Security Camera System Recorder, 8MP Security DVR for Analog Security Cameras & Amcrest IP Cameras, Remote Smartphone Access, HDD & Cameras NOT Included (AMDV8M8-H5)
11121314151617181920
18
Step 1: Connect a BNC (coaxial) cable to the video out connection of your camera.
Step 2: Connect the male end of the DC power connector of the BNC (coaxial) cable to the female end of the
power connector of the camera.
Step 3: Connect the BNC (coaxial) cable to a video out channel on the back of your DVR.
Step 4: Connect the male end of the DC power connector of the power adapter to the female end of the power
connector of the BNC (coaxial) cable. Plug in the power adapter to apply power to the camera.
For more information on the installation process described, refer to the image below for more details.
3.5 Factory Reset Procedures
Newer Amcrest model DVRs, such as the XVR or S5 models, will have a different factory reset process than its
previous counterparts.
To begin the process, you will need to remove the DVR cover. Use a Phillips head screwdriver to remove the four
screws on the back and sides of the DVR. Once the screws have been removed, lift the lid to expose the DVR's
motherboard.
On the motherboard you will notice a small black button. This is the factory reset switch for your DVR: