Wiring Sheet

ManualsBrandsAmana ManualsAppliances30 in. 4.8 cu. ft. Electric Range in Stainless Steel

FOR SERVICE TECHNICIAN’S USE ONLY

W11326823A

ACTIVATING THE SERVICE DIAGNOSTIC MODES

1. Enter Diagnostics Mode by pressing CANCEL>CANCEL>START within 5

seconds.

2. Press the “up” arrow keypad to scroll through the diagnostics settings.

NOTES:

■ Entering Diagnostics mode will cancel any active oven operation.

■ Enter the Diagnostics mode only after the oven is cool.

Code Description

No display Control not operational

F1E0

F1E1

F1E2

Internal board failure

A/D Error(s)

F2E1 Shorted keypad

F3E0 Oven sensor opened

Oven sensor shorted

Bake/Broil range over temperature

Clean range over temperature

F5E0 Door and switches do not agree (Clean mode)

F5E1 Door latch not operating (Clean mode)

F6E1 Oven over temperature when heating

F9E0 Miswired house

Miswired range

ERROR CODES

RESISTANCES

Component Pinout Resistance or Voltage

Door switch P3-1 to P3-2 2 VDC with door open

0 VDC with door closed

Oven temp sensor P3-4 to P3-5 1000-1200 Ω at room temperature.

Oven light P2-1 to WH (neutral) P1-3 0-40 Ω nominal

Bake element P4-3 to P5-4 10-40 Ω nominal

Broil element P5-1 to P5-4 10-40 Ω nominal

Thermo fuse P5-1 to P5-4 240 VAC

Door latch motor P3-3 to WH (neutral) P1-3 500-3000 Ω

Radiant element (single) H1 to H2 240 VAC

Radiant element (dual) H1A to H2 240 VAC

Coil element H1 to H2 240 VAC

DANGER

Electrical Shock Hazard

Only authorized technicians should

perform diagnostic voltage measurements.

After performing voltage measurements,

disconnect power before servicing.

Failure to follow these instructions can

result in death or electrical shock.

Voltage Measurement Safety Information

When performing live voltage measurements, you must do the following:

■ Verify the controls are in the off position so that the appliance does not start when energized.

■ Allow enough space to perform the voltage measurements without obstructions.

■ Keep other people a safe distance away from the appliance to prevent potential injury.

■ Always use the proper testing equipment.

■ After voltage measurements, always disconnect power before servicing.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before

operating.

Failure to do so can result in death or

electrical shock.

Summary of content (2 pages)

PAGE 1
FOR SERVICE TECHNICIAN’S USE ONLY W11326823A WARNING DANGER Electrical Shock Hazard Only authorized technicians should perform diagnostic voltage measurements. After performing voltage measurements, disconnect power before servicing. Failure to follow these instructions can result in death or electrical shock. Code Replace all parts and panels before operating. ■ ■ ■ Verify the controls are in the off position so that the appliance does not start when energized.
PAGE 2
© 2019 FOR SERVICE TECHNICIAN’S USE ONLY W11326823A IMPORTANT: Electrostatic discharge may cause damage to machine control electronics. Refer to online Tech Sheet for additional information. Check for proper voltage by completing the following steps: 1. Disconnect the power or unplug the appliance. 2. Connect voltage measurement equipment to proper connectors. 3. Plug in appliance or reconnect power and confirm voltage reading. 4. Disconnect the power or unplug the appliance.