Installation & Assembly (Full)

t it is intended for. Approximately

Allen Wrench M6 x1

Page 1 of 3

Hardware:

Component:

Bolt M8x20mm x16

Nut M6 x9

Allen Wrench M8 x1

Short Board

Thank you for purchasing the FULL/QUEEN BED FRAME！

Before you start, here are some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simpl

e step by step

nstructions.

2.Owing to the size and weight of the bed frame, we recommend that it is assembled by two adults, on a carpeted

or padded area, in the room tha assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is

fully assembled. Please ensure that the packaging is dispose

d of in a safe

nvironmentally friendly wa

5.A

ssemble all components loosely until advised to tighten. Depending on use, it may be necessary to tigh

ten the

component

s from time to time, so please save the tools that has been provide

6.Please

keep all fitting out of reach of childre

Open Wrench x1

Side Plastic Cover x24

Long Board x2

Leg x4

Center Rail x1

Support Leg x4

Stretcher x1

Slat x24

Bolt M6x55mm x1

Bolt M6x35mm x10

Center Plastic Cover x12

Flat Washer x13

Bolt M6x20mm x4

Flat Washer x16

PAGE 1
Thank you for purchasing the FULL/QUEEN BED FRAME！ Before you start, here are some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the bed frame, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approximately assembly time: 30 minutes. 3.
PAGE 2
FULL/QUEEN BED FRAME STEP 1: Insert the end of Leg (3) into Short Board (1) and Long Board (2) as shown. Secure by using 4 pieces of Bolts (A) and Flat washer M8 (L) , tighten Bolts (A) by using Allen Wrench (C) . Repeat the same steps for the remaining 3 pieces of Legs (3). . Dot not fully tighten Bolts (A) at this step. 2 1 3 insert 2 3 1 3 3 2 1 3 2 L L A A 3 L L 1 A A C Ax16 L x16 Cx1 Hardware & Tool required STEP 2: Place 1 piece of Support Leg (6) under Center Rail (5) as shown.
PAGE 3
FULL/QUEEN BED FRAME STEP 3: Place Stretcher (4) to the middle holes of as sembled Long Board (2) and Center Rail (5) as shown. Secure the end of Stretcher (4) by using 2 pieces of Bolts (H) as shown. Secure the middle of Stretcher (4) by using 1 piece of Bolt (G) and Flat Washer (K). Tighten Bolts (G) by using Allen Wrench (F ) and Nut (B). Dot not fully tighten Bolts (G) at this step.