User's Manual

Appendix B. Basic Parameters
SU-R Installation Manual 23 BreezeACCESS II Series
Appendix B: Basic Parameters
•
IP Address
– Displays the current IP address of the unit and allows entry of a new IP address
(4 x 3 digit octets, separated by dots). The default IP Address is 010.000.000.001.
•
Subnet Mask
– Displays the current subnet mask of the unit and allows entry of a new
subnet mask (4 x 3 digit octets, separated by dots). The default mask is 255.000.000.000.
•
Default Gateway Address
– Displays the current address of the default gateway of the unit
and allows entry of a new default gateway address (4 x 3 digit octets, separated by dots). The
default gateway address is 000.000.000.000.
•
DHCP Client
⇒
DHCP Options
– Displays the current status of the DHCP (Dynamic Host Configuration
Protocol) support, and allows selecting a new operation mode. The available options are:
∗
Disable
– Use manual procedure for configuring the IP parameters.
∗
DHCP Only –
Search for a DHCP Server and obtain the IP parameters from it (IP
Address, Subnet Mask and Default Gateway Address).
∗
Automatic –
Search for a DHCP Server for configuration of the IP parameters. If a
DHCP Server is not found within approximately 40 seconds, use the currently
configured IP parameters.
The default is Disable.
⇒
Access to DHCP
- To define the port through which the unit is allowed to communicate
with a DHCP server. The options are the following:
∗ From Wlan Only
∗ From Ethernet Only
∗ From Both Ethernet & Wlan
The default for an Access Unit is From Ethernet Only. The default for a Subscriber Unit is
From Wlan Only.
•
ESS ID
– The ESSID (Extended Service Set ID) of the unit (up to 32 printable ASCII
characters). The ESSID is a string used to identify a wireless network. It prevents the
unintentional merging of two co-located wireless networks. An SU can only associate with an
AU that has an identical ESSID. Use different ESSIDs to segment the wireless access network
and add security to your network. The default value is
ESSID1
.