User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
IF Based Equipment
1-9
BreezeACCESS 4.0 System Manual
Table 1-5: AU-RE LEDs
Pole Mounting the Outdoor Unit
The outdoor unit can be secured to the pole using one of the following
options:
! Special brackets and open-ended screws (supplied with each unit).
There are two pairs of screw holes on the back of the unit, allowing
use of the special brackets with various pole widths.
! U-bolts – size A (inner installation holes, up to 2" pole).
! U-bolt – size B (outside installation holes, up to 3" pole).
! Metal bands (9/16" wide, minimum 12" long).
Figure 1-3‚ page 1-10 shows the locations of the U-bolt holes, band
grooves and screw holes on the rear side of the outdoor unit.
Figure 1-4‚ page 1-10 illustrates the method of installing an outdoor
unit on a pole, using the brackets and open-ended screws.
Name Description Functionality
ETH Ethernet activity Blinking – Data received from or transmitted to
Ethernet LAN
Off – No activity on the Ethernet LAN
12V IN Power On – 12 VDC power is supplied to the unit
Off – 12 VDC power is not available
ALARM Alarm indication On – A problem with the power amplifier or in the
locking process of any of the synthesizers
Off – Normal operation
NOTE:
Make sure to install the unit with the bottom panel (the panel with the IF connector)
facing downward.