User's Manual
Table Of Contents
- System Manual Book 1: System Description
- Introduction
- System Components
- Specifications
- System Specifications
- Radio and Modem
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication (SU-A/E, AU-E-NI, AU-E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- System Manual Book 2: Installation
- IF-Based Equipment
- Packing Lists
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- IF-Based Equipment
- System Manual Book 3: Commissioning
- System Manual Book 4: Operations and Administration
- Accessing the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Configuration Download/Upload
- System Manual: Appendices
2-10
BreezeACCESS 4.0 Operations and Administration
Manual Revision: 1.01
Basic Configuration Menu
The Basic Configuration menu includes all the parameters that are
necessary for the initial installation and operation of the unit. Once the
unit is properly installed and operational, other parameters can be
configured either locally using the monitor program or remotely using
Telnet, SNMP management or TFTP for loading to the unit a
pre-prepared configuration file.
For more information about the initial configuration of BreezeACCESS
units, see Book 3: Commissioning.
The Basic Configuration menu includes the following submenu
parameters:
IP Parameters
! IP Address (see page 2-21)
! Subnet Mask (see page 2-21)
! Default Gateway Address (see page 2-21)
! DHCP Client (see page 2-22)
Air Interface Parameters
! ESSID (see page 2-33)
! Operator ESSID Parameters (AU) (see page 2-33)
! Hopping Band* (see page 2-22)
! Flexible Hopping Definition* (see page 2-24)
! Hopping Sync (AU-BS) (see page 2-35)
! Hopping Shift (AU-BS) (see page 2-28)
! Best AU Parameters (SU) (see page 2-35)
" Best AU Support
" Preferred AU MAC Address
! Maximum Data Rate (SU) (see page 2-36)
*The Hopping Band and Flexible Hopping Definition parameters are not
available in units configured in the factory to operate in ISM US FCC
hopping standard only (US Option).
VLAN Parameters
! VLAN ID – Management (AU and SU without voice support) (see
page 2-44)