User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 266 System Manual
4.3.10.6.2 Restoring the Default Configuration Parameters for the Authenticator
Function
To restore the default configuration for the Authenticator function, run the
following command:
npu(config)# no authenticator [eapidreq-retries]
[eapidreq-interval] [ntwentry-holdtime] [eaptransfer-retries]
[eaptransfer-interval] [reauth-attempts] [reauthcmplt-holdtime]
[eaptransfer-roundtrips] [pmk-lifetime] [pmk-guardtime]
[authfailure-holdtime] [max-ntwentry]
[pmk-guardtime
<timeout>]
Denotes the duration of the
guard timer for the MS
authentication keys. the NPU
initiates re-authentication for
the MS after the pmk guard
timer has expired. (The value
of this timer is
pmk-lifetime -
pmk-guardtime.)
If the value of this parameter
is 0, the guard timer is not
started.
Optional 0 0-86400
[authfailure-h
oldtime
<timeout>]
Denotes the period, in
seconds, for which the MS
context is retained after
authentication failure.
Optional 0 1-1024
[max-ntwentry
<counter>]
Denotes the maximum
number of times that the NPU
may handle a network entry
request from an MS, after
prior attempts for that MS has
already failed. After the NPU
has handled max-ntwentry
number of attempts and its
value is 0, the MS is assigned
the unauthenticated mode.
Optional 3 0-10
Command
Modes
Global configuration mode