User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 263 System Manual
4.3.10.5.2 Displaying Configuration Information for the ASN Interface
To display the IP interface (R4/R6) of the ASN interface, run the following
command:
npu# show asnif
4.3.10.6 Managing the Authenticator Function
The Authenticator function of the NPU manages MS authentication for accessing
WiMAX network resources. It also maintains context information for each MS that
has accessed or is trying to access the network. For this, it handles all key
derivations and distribution. In addition, it uses AAA client functions to send
RADIUS messages on the R3 interface.
This section describes the commands to be used for:
 “Configuring Parameters for the Authenticator Function” on page 263
 “Restoring the Default Configuration Parameters for the Authenticator
Function” on page 266
 “Displaying Configuration Information for the Authenticator Function” on
page 267
4.3.10.6.1 Configuring Parameters for the Authenticator Function
To configure the parameters of the Authenticator function, run the following
command:
Command
Syntax
npu# show asnif
Privilege
Level
1
Display
Format
ASN Interface Configuration :
ASN IP Interface = <value>
Command
Modes
Global command mode